Filtering beer with 0.1 micron absolute filter

Beer prior to filtration, I’d tried gelatin + kieselsol for around 2 week now in total at 0.4C:

Temp reading:

Using the Sawyer SP-128 Filter:

The results!:

Notes

  • The filtered beer definitely tastes different (I am not planning to do this on all my beer)
  • I noticed that when I attached this tiny filter in line to a corny keg, it does clog fast (back flushing with clean water does help fix it, but that’s only a temporary fix)! So I’m planning to add a 0.5 micron absolute filter prior to it, in 5″ or 10″ filter housing.
  • Because this is sterile filtration (which will remove the yeast), I will add bottling yeast, when bottling and priming.
  • Instead of filtering all beer, I’m going to alter my process including taking steps to encourage precipitation of cold break, by chilling potentially to 0C after boiling, leaving for a while then increasing to pitch temp.

4 Comments
  • Eugene
    October 30, 2017 Reply

    what’s the difference in taste w/filter?

    • admin
      October 31, 2017 Reply

      Hi,

      Unfiltered: More of a bready aroma. Definitely seems to have more taste, bready, possibly more bitterness too I think.
      Filtered: Less aroma Less bitterness and breadiness in taste. Definitely seems lighter to me in taste, although I won’t say the original beer was brilliant.

      Hope that helps.

  • Cullen
    February 5, 2021 Reply

    Does adding the yeast after bottling cause it to go murky again?

    • admin
      February 8, 2021 Reply

      That’s a good question, I didn’t try adding yeast+sugar to bottles after doing this.

      I found adding irish moss in the form of protafloc 15 mins before the end of boil, then whirlpooling after seemed to help with my clarity issues recently.

Leave Comment

Click here to cancel reply

Error Please check your entries!